See StefanScherer/OpenSprinkler-Firmware for the two added files. I have forked the OpenSprinker-Firmware repo and added a Dockerfile and. The following wiring is used to connect from the outdoor case of the RainDial Plus to the OpenSprinkler Pi running indoors.Ĭonnecting the wires to the OpenSprinkler Pi board will be done like this:Īfter removing the old boards and installing the OpenSprinkler Pi board the setup looks like this:Ī Raspberry Pi 2 running HypriotOS with Docker CE 17.03 is running the OpenSprinkler service in a Docker container. The RainDial Plus AVR board will be replaced, Pollin Board, the power supply board and the relais board. duolingo xp hack 2022 blazor scheduler github pickleball courts in kitsap county colony square cinema 7 suzuki df20a thermostat location stellaris plentiful traditions vs expanded traditions mn unemployment employer login best gps tracker for car in india raspberry pi copy sd card to larger. Remember at that time you could not buy a Raspberry Pi.īut maintaining it is very hard, so it was time to move on to a big fat solution running on Raspberry Pi 2 (900 MHz, 1 GByte RAM, 8 GByte SD card): The good old 56 KByte web app stored in the small firmware of an ATMega644 (20 MHz, 64 KByte flash memory, 2 KByte EEPROM, 4 KByte SRAM) still does its job on my iPad 1 and 3. All OpenSprinkler design files, including circuit schematic, board design, firmware code, app code, can be found on the OpenSprinkler Github repository. This short weekend project replaces my initial hardware project back from 2010 using the Pollin Board and Ethersex firmware with OpenSprinkler Pi.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |